E6000 adhesive provides a very strong bond with Non-Hotfix Flatback Crystals and:

1. Fabric (See our Flatback Crystal Fabric Glue test for E6000 Vs Fabrics bond strength )
2. Wood
3. Metal
4. Glass / Rhinestones
5. Rubber (no longer suitable for Havaianas see post Havaianas Glue test )

E-6000 adhesive is also:

1. Flexible
2. Water-Proof
3. Non-Flammable
4. Paintable
5. Permanent Bond

Directions For Use

1. Surface should be clean, dry, and free of any dust or grease, you can use rubbing alcohol to clean the surface if necessary.
2. For best results to improve the bond between the adhesive and material lightly roughen up the surface of the material with a fine sand paper or emery board.
3. Apply enough adhesive for a few crystals at a time as e6000 dries very quickly and always put the top back on the tube between use to prolong the life of the adhesive. If you leave the top off the glue it will thicken and eventually set.
4. When attaching crystals to fabrics like suede the crystal may need to be held in place for 10 seconds or so before the adhesive gets a purchase on the material.
5. Excess glue should be removed off crystals before it dries or with the use of an acetone based product like nail varnish remover or a citrus-based solvent.
6. For Curing correctly Adhesive can be used between temperatures of 50 and 90 degrees F and 10 and 32 degrees C.
7. When Fully Cured E6000 has a temperatures range of between -40 and 150 degrees F.
8. Excess glue should be removed off crystals before it dries or with the use of an acetone based product like nail varnish remover or a citrus-based solvent.

Please note * Care should be taken when using E-6000 as fumes are harmful if inhaled or swallowed and chemicals in the adhesive have been found to cause cancer.

More information

1. E6000 technical Data Sheet
2. How to apply crystals to shoes
3. How to apply crystals to iphone case
4. How to apply crystals to Converse